Vakuuma sūknis MEC1000P

Õlidosaator ei kuulu komplekti ! Details: -Each pump is subjected to a final check in the factory, in which the vacuum, compression and lubrication are tested, among other factors -A test report relating to the serial number is drawn up for each pump Application range: These vacuum pumps with vanes are mainly used in agriculture for filling and emptying slurry tanks Properties: These pumps can generate both positive pressure and vacuum Technical info: -Composition of the item numbers: MEC = series, 8000 = type, P = pulley drive -Pumps with an "L" in the item number must be driven anti-clockwise; pumps without an "L" in the item number must be driven clockwise -On pumps without automatic lubrication (no "A" in the item number), the pump is equipped with a forced lubrication system that is adjusted using dripper nozzles Automatic lubrication available on request -On pumps without automatic lubrication, the quantity of lubrication oil is set in the factory and cannot be changed without a tool -In the case of forced lubrication, as with automatic lubrication, the function must be checked at all times during operation -The direction of rotation is determined when the axle to be driven is aligned with the observer -Oil to be used for lubricating the vanes: genuine oil from B. P. (item number BP5070) Benefits: As B.P. pumps are tested, inspected and packaged with the utmost care, trouble-free start-up is 100% guaranteed Nominal volume flow rate: 1260 l/min Drive type: Pulley Direction of rotation: Clockwise (CW) Ballast air injection system: No Consists of: -These pumps are supplied with standard vanes. Long-life vanes available on request -Without pressure relief valve and vacuum valve -The pumps are delivered without lubrication oil (item BP5070) -Without pulley Lubrication system type: Forced Vane type: Standard Crash protection system: No Max vacuum: 0.9 BAR Max. relative pressure: 1.5 BAR Power requirement for max. vacuum: 2.2 kW Diameter of hose connection: 27 mm A Total length: 265 mm B Total width: 263 mm C Height: 362 mm H Mounting holes diameter: 11 mm I Mounting holes distance: 175/73 mm Mounting holes to shaft end distance: 120 mm Mounting holes to end distance: 72 mm Shaft centre to left side end distance: 117 mm Shaft centre to right side end distance: 146 mm Shaft centre to bottom distance: 111 mm Max. shaft rotation: 1400 r/min Weight: 33 kg Additional info: *Please note that this item is either a dangerous good or a non-standard delivery size. This means a specialist carrier will be used and this item will take upto 48 hours to deliver.